Technoline WS1700 Mode D'emploi page 35

You can manually adjust the clock to the time zone of a country (up to 1500km distance to
Frankfurt/Main) where the clock receives the DCF77 signal but where the actual time
differs from the time received.
If, e.g. the time in a given country is 1 hour ahead of the German time, set the time zone
display to 01. The clock is now DCF77 controlled but the time is one hour ahead.
Daily alarm set-up

Press "MODE" to switch to "Alarm1" mode, "A1" and the alarm displayed

Press and hold the key "MODE" for 3 seconds ,the flashing alarm time are shown

The hour display of the alarm time is flashing. Use "UP "and "DOWN" to select the hour.
Press "MODE" to confirm.

Then follow the minutes. Use "UP " and "DOWN " to select the minutes,

Press "MODE" to confirm.

Then press "MODE" to switch to "Alarm2" mode, "A2" and the alarm displayed

Press and hold the key "MODE" for 3 seconds ,the flashing alarm time are shown

The hour display of the alarm time is flashing. Use "UP "and "DOWN" to select the hour.
Press "MODE" to confirm.

Then follow the minutes. Use "UP " and "DOWN " to select the minutes,

Press "MODE" to confirm.
Daily alarm on/off

Press "MODE" to switch from time display to "Alarm 1" or "Alarm 2" mode

When showing A1 or A2 alarm time, press "UP"or "DOWN" to activate the alarm with
alarm symbol showing.

Press "UP' or "DOWN" again to cancel the alarm
Information:

The clock automatically changes from set-up mode to time mode if no keys are pressed
for 20 seconds.

The alarm sounds for 2 minutes if no key is pressed to stop it.
Snooze function
To activate the snooze function, follow the steps below

Press the key "SNOOZE/LIGHT", while the alarm sounds, to activate the snooze function.

If the snooze function is

The alarm repeat after 5 minutes.

The snooze function can be stopped by pressing any other key than "SNOOZE/LIGHT"..
activated, alarm symbol is flashing.