Pressure Relief Procedure; Spraying Technique; Cleanup - Titan MULTIFINISH 440 Mode D'emploi

Solid Green
When the pressure indicator is solid green, the sprayer is operating
between 1901 and 3300 PSI. A solid green pressure indicator means:
• The sprayer is at the proper pressure setting for spraying oil-
based and latex house paints
• The sprayer is operating at peak performance at a high
pressure setting
Motor Running Indicator
The Motor Running indicator is on when the motor is commanded to
run. This indicator is used by service centers to troubleshoot motor
problems.

Pressure Relief Procedure

Be sure to follow the Pressure Relief Procedure when
shutting down the sprayer for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for

cleanup.

1. Make sure the pressure control knob is in its OFF position in
the white zone.
2. Turn the PRIME/SPRAY valve to the
PRIME position.
3. Trigger the gun to remove any
pressure that still may be in the
hose.
4. Lock the gun by flipping the
trigger lock into lock position (see
spray gun manual).
INJECTION HAZARD. Do not spray without the tip
guard in place. Never trigger the gun unless the tip
is in either the spray or the unclog position. Always
engage the gun trigger lock before removing,
replacing, or cleaning tip.
© Titan Tool Inc. All rights reserved.

Spraying Technique

The key to a good paint job is an even coating over the entire surface.
This is done by using even strokes. Keep your arm moving at a
constant speed and keep the spray gun at a constant distance from
the surface. The best spraying distance is 10 to 12 inches between the
spray tip and the surface.
Even coat throughout
Keep stroke smooth and at an even speed.
Keep the spray gun at right angles to the surface. This means moving
your entire arm back and forth rather than just flexing your wrist.
Light Coat
Do not ex wrist while spraying.
Keep the spray gun perpendicular to the surface, otherwise one end
of the pattern will be thicker than the other.
The spray gun should be triggered by turning it on and off with each
stroke. This will save paint and avoid paint buildup at the end of the
stroke. Do not trigger the gun during the middle of a stroke. This will
result in an uneven spray and splotchy coverage.
Proper way to trigger the spray gun
Keep stroke
even
Start stroke Pull trigger
Overlap each stroke by about 30%. This will ensure an even coating.
When you stop painting, lock the gun trigger lock, turn the pressure
control knob counterclockwise to its lowest setting and set the
priming knob to PRIME. Turn the motor switch to OFF and unplug the
sprayer.
7
Approximately
10 to 12 inches
Heavy Coat Light Coat
Approximately
10 to 12 inches
Keep steady Release trigger End stroke
English