Installation Steps - AVS Ventvisor Deflector Instructions D'installation

Installation Steps

Scuff rubber trim where drivers side visor
mounts with scotch brite pad. Then clean
with alcohol pad. Repeat for all (4) doors.
mirror cap
1
Peel back 2" (5cm) of tape liner from the front and rear
tape liner
rear end flange
3
With the visor in its final position, remove the remain-
der of the tape liner by pulling on free ends.
5
The drivers side rear visor attaches to the rubber trim
utilizing the same procedure.
rear visor in
final position
7
NOTE: Actual application may vary slightly from illustrations.
flanges.
tape liner
front end flange
Apply one coat of surface prep to previously
cleaned rubber trim on all (4) doors promptly
2
Align the drivers side visor with previously cleaned
rubber trim. Slide the front end flange under the mirror
cap. Press exposed area of tape.
free end
slide under
mirror cap
4
Apply pressure along flange edges to ensure proper
6
Repeat Steps 1-7 for passenger side.
Page 2 of 3
to prevent evaporation.
prep rubber trim
free end
adhesion.