Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Important Safety Information
• CAUTION - Before driving, ensure that the vent visors are properly secured to vehicle.
• Do not use automatic "brush-style" car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
• When using Surface Prep, avoid contact with skin. Use in well ventilated area. If contact is made with
material, flush area with large amounts of water. If irritation persists, get immediate medical
attention. USE PREP ON RUBBER ONLY
Contents - 2 Piece Set
Front Driver
Side Visor
Contents - 4 Piece Set
Front Driver
Side Visor
Alcohol Pad x2
Tools Required
Preparation Before Painting / Installation
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash your vehicle to remove any debris and/or dirt.
• Dry with a clean towel.
Installation Instructions
Ventvisor
®
NOTE: Actual product may vary from illustration.
Front Passenger
Alcohol
Side Visor
Front Passenger
Side Visor
Scotch Brite Pad
Car Wash Supplies
Page 1 of 3
Deflector
Scotch Brite Pad
Pad x2
Rear Driver
Side Visor
Clean Towel
I - Sheet Number VV05 Rev.D
Surface Prep
Rear Passenger
Side Visor
Surface Prep

Publicité

Table des Matières
loading

Sommaire des Matières pour AVS Ventvisor Deflector

  • Page 1 Installation Instructions I - Sheet Number VV05 Rev.D Ventvisor Deflector ® For proper installation and best possible fit, please read all instructions BEFORE you begin. For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219. Important Safety Information •...
  • Page 2: Installation Steps

    Installation Steps NOTE: Actual application may vary slightly from illustrations. Scuff rubber trim where drivers side visor Apply one coat of surface prep to previously mounts with scotch brite pad. Then clean cleaned rubber trim on all (4) doors promptly with alcohol pad.
  • Page 3: Care And Cleaning

    Lund International 800-241-7219 • Visit us at lundinternational.com © 2018 Lund, Inc. All rights reserved. Auto Ventshade™, the Auto Ventshade™ logo and the AVS™ logo are trademarks of Lund, Inc. ™ Page 3 of 3...
  • Page 4: Outils Nécessaires

    Instructions d’installation I- Feuille numéro VV05 Rév.D Déflecteur Ventvisor ® Pour obtenir une installation correcte et le meilleur ajustement possible, lire toutes les instructions AVANT de commencer. Pour toute assistance technique ou obtention de pièces manquantes, appeler le service des relations avec la clientèle au 1-800-241-7219.
  • Page 5: Étapes D'installation

    Étapes d’installation REMARQUE : La méthode d’application peut être légèrement différente de celle représentée par les illustrations. Enduire la garniture en caoutchouc Frotter la garniture en caoutchouc, à précédemment nettoyée des (4) portières l’emplacement de montage de la visière côté d’une couche de produit de préparation de conducteur, avec le tampon à...
  • Page 6: Entretien Et Nettoyage

    Lund International 800-241-7219 • Visitez notre site lundinternational.com © 2018 Lund, Inc. Tous droits réservés. Auto Ventshade™, le logo Auto Ventshade™ et le logo AVS™ sont des marques déposées Lund, Inc. ™ Page 3 de 3...
  • Page 7: Herramientas Necesarias

    Instrucciones de instalación Hoja informativa N.° VV05 Rev.D Deflector Ventvisor ® Para una instalación adecuada y el mejor ajuste posible, lea todas las instrucciones ANTES de comenzar. Si desea recibir asistencia técnica u obtener piezas faltantes, llame al Servicio al cliente al 1-800-241-7219. Información importante de seguridad •...
  • Page 8: Pasos De Instalación

    Pasos de instalación AVISO: La colocación real puede variar con respecto a las ilustraciones. Pula la banda de goma donde se montan las Aplique una capa de preparador de viseras del conductor con el paño Scotch superficies a la banda de goma limpiada Brite.
  • Page 9: Cuidado Y Limpieza

    Lund International 800-241-7219 • Visite nuestro sitio Web: lundinternational.com © 2018 Lund, Inc. Todos los derechos reservados. Auto Ventshade™, el logo de Auto Ventshade™ y el logo de AVS™son marcas comerciales de Lund, Inc. ™ Página 3 de 3...

Table des Matières