Installation Steps
Locate (2) rubber trim pieces on the underside of hood. On each
side, locate and remove the retainer that is located second from the
remove
retainer
rubber trim pieces
3
Insert a fastener through rubber trim piece and hood shield, and into hood on each OUTBOARD flange. Tighten fastener.
5
Place a washer over a screw and insert through hood shield and into hood. Repeat for remaining holes. Tighten screws.
6
7
NOTE: Actual application may vary slightly from illustrations.
front.
remove
retainer
NOTE: DO NOT OVER TIGHTEN
NOTE: DO NOT OVER TIGHTEN
Center part on front edge of hood and align holes. Slide the out-
board flanges UNDER the rubber trim pieces.
4
Close Hood.
Page 2 of 3
Outboard flanges UNDER
rubber trim pieces
hood
hood shield
rubber trim
fastener
hood
insert
hood shield
washer
screw