Installation Steps - AVS Aeroskin LightShield Instructions D'installation

Installation Steps

NOTE: Actual application may vary slightly from illustrations.
First, clean the recessed area of the LightShield with an alcohol pad and allow to dry.
Next, apply one coat of Surface Prep to the same area.
1
Straighten the Light strip and allow it to relax and Peel back 2" of tape liner from each end of the backside of the Light
flatten out. strip. Fold the tape tabs over so that the free ends are accessible.
free end free end
2 3
Electrical wire
Thread electrical wire through hole in the corner of the LightShield and position Light strip along recessed area of LightShield.
Electrical wire threaded through hole
and along backside of LightShield
4
Carefully align the Light strip in place along the recessed area of the LightShield. Once positioned, press down on the exposed
area of tape to tack the Light strip in place. Ensure that free ends of tape tabs are accessible.
free end free end
5
Page 2 of 6