AVS Aeroskin LightShield Instructions D'installation page 4

Installation Steps
12
Expose 2" (5 cm) of tape liner from each section of LightShield. Ensure you can access the free ends of tape liner.
Apply a piece of masking tape to hold electrical wire in place. Be sure to route wire in between tape segments.
FAR SIDE EDGE
free end
free end
free end
FAR BOTTOM EDGE
13
Masking Tape
Center the Aeroskin on the hood. Part should be positioned about 1/16" (1.5mm) from hood edge on all sides.
14
Apply LIGHT PRESSURE to the exposed tape at CENTER LOCATIONS ONLY to tack LightShield in place. Raise hood slightly.
15
NOTE: Actual application may vary slightly from illustrations.
Use the alcohol pads to clean the entire LEADING EDGE of the hood.
NOTE: Inspect part thoroughly to confirm all sections of tape liner are exposed.
CENTER TOP
free end
DO NOT APPLY PRESSURE IN THIS STEP
CENTER TOP
free ends
free ends
CENTER BOTTOM
Electrical wire
Page 4 of 6
CENTER TOP free end
free end
free end
FAR BOTTOM EDGE
NOTE: Some applications do not
have side tape by design.
FAR SIDE EDGE
free end