Care And Cleaning - AVS Aeroskin LightShield Instructions D'installation

Installation Steps
Press firmly along all edges of LightShield to ensure adhesion
of tape to hood surface.
20
Determine location to route electrical wire so that it will be secure and does not interfere with any existing equiptment.
3-4 Wire Stays are used to hold the electircal wire in position. Clean mounting locations with an alcohol pad, then remove
adhesive backing from Wire Stays. Adhere Wire Stays to hood and route electrical wire through them.
22
NOTE: Connect the red wire to the marker light circuit. Connect the black wire to vehicle ground.
To connect electrical wire to hot wire: (1) Insert hotwire in slot on threaded screw, (2) Tighten screw against connector,
(3) Strip leads from electrical wire, (4) Insert electrical wire in screw. Tighten onto opposite end of connector.
Insert Hot Wire
1
23

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade™, the Auto Ventshade™ logo and the AVS™ logo are trademarks of Lund, Inc.
™
NOTE: Actual application may vary slightly from illustrations.
Tighten
2
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2019 Lund, Inc. All rights reserved.
Raise hood, and route electrical wire under front edge of
21
Example of Wire Stays
placement locations
electrical wire
Repeat for ground wire.
Strip Leads
3
The material that your product is made from can
be recycled. Please also consider recycling the
Page 6 of 6
hood.
Insert and Tighten
4
packaging that your product came in.
electrical wire