Installation Steps; Care And Cleaning - AVS Bugflector Instructions D'installation

Installation Steps

NOTE: On vehicles equipped with factory weatherstrip, it is neces-
sary to pull the weatherstrip down slightly to expose holes.
3
Align pre-drilled holes in hood shield with holes in hood. Place
hood shield on hood.
NOTE: On vehicles equipped with factory weatherstrip, the hood
shield will slide in between the weatherstrip and the hood.
5
Adjust bumper stops as needed to ensure hood shield clears grille
and headlights.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International. We take the utmost pride in our products
and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms of
fit, durability, finish and ease of installation.
Auto Ventshade™, the Auto Ventshade™ logo and the AVS™ logo are trademarks of Lund, Inc.
™
NOTE: Actual application may vary slightly from illustrations.
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2020 Lund, Inc. All rights reserved.
Press (6) hood inserts into the (6) square holes. If
necessary use tape to hold them firmly in place.
4
Using a phillips screwdriver install (6) screws with (6)
washers at the locations noted in Step 2.
hood insert
hood shield
weatherstrip
(if equipped)
6
Close hood, and install bump ons at pre-cleaned loca-
8
The material that your product is made from can
be recycled. Please also consider recycling the
Page 2 of 2
square hole
hood
washer
screw
DO NOT OVER TIGHTEN
tions on the painted hood surface.
packaging that your product came in.