Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Clean the door's painted surface & mirror
cap where the visor will attach.
1
Attach front flange to mirror cap Attach the top and rear
flanges to the door's painted surface. Remove tape liner
by pulling on free ends.
3
4 Piece Set
5
NOTE: Actual application may vary slightly from illustrations.
The rear visor attaches with same preparation methods as the front visor.
Attach visor to the vehicle's painted surface.
Remove the tape liner from the front & rear flanges.
Peel back 2" of tape liner from each end of top flange.
rear
flange
2
Apply pressure to top and rear tape flanges to secure.
4
OR
Page 2 of 3
top flange
flange
free end
front
Publicité
Table des Matières
