AVS Aeroskin LightShield Instructions D'installation page 5

Installation Steps
Wrap foam tab around hood edge OVER WIRING and secure the electrical wire in a protected position. Carefully lower hood.
16
Begin removing remaining tape liner, beginning with the drivers side CENTER TOP sections. Grasping the free end, pull tape gently in 6"
(15 cm) sections, while applying even pressure with hand to LightShield. Repeat process for passenger side.
17
NOTE: Do not apply pressure closer than 6" (15 cm) to tape liner as it could accidentally break.
Using the same process, remove tape liner from the driver side CENTER BOTTOM of LightShield. Repeat for passenger side.
18
Again using the same process, remove tape liners from the driver side FAR SIDE EDGES and FAR BOTTOM EDGES of LightShield.
19
NOTE: Actual application may vary slightly from illustrations.
NOTE: Use caution not to pinch electrical wire while closing hood!
Repeat for passenger side.
Page 5 of 6
CAUTION: You must apply
even pressure from center
section out to each end
of part, in order for proper
adhesion to hood.
CAUTION: You must apply even
pressure from center section out to
each end of part, in order for proper
adhesion to hood.
NOTE: Some applications do not
have side tape by design.
foam tab
electrical wire