Pxlan/Pxweb Lan Interfaces; Circuit Board Description; Installation; Pxknx - CAME PXC48 Manuel Installateur

PXLAN/PXWEB LAN INTERFACES

The PXLAN interface allows you to programme, read the settings
and display the control unit status from a PC using the PxManager
program .
The PXWEB interface, on the other hand, in addition to providing
the functions of the PXLAN interface, allows the control unit to be
controlled via a keypad duplicated from a webpage .
For remote connection to the PXLAN and SPXWEB interfaces,
the router connected to your home network must be configured
(see the relative instruction manual) .

CIRCUIT BOARD DESCRIPTION

For correct operation of the control unit the links [JP1] - [JP2]
pos . ⑤ must remain in position A .

INSTALLATION

All the operations to insert and remove the card must be
carried out with no power to the control unit .
1 . Terminal board for con-
nection to master Touch
Screen (only for PXWEB)
2 . LAN connection
3 . Connector for connection
to control unit
4 . Reset and restore to de-
fault button
5 . Select type of communi-
cation (only for PXLAN, de-
fault A)
Once the four spacers provided
are attached to the card (either
SIP or IFLAN), it can be inserted
into the relevant holes on the
back of the container (top left) .
To configure the devices,
see the relative instruction
manuals .

PXKNX

The PXKNX interface card considerably enhances the commu-
nication opportunities of Proxinet control units, allowing them to
communicate with the KNX system . It is connected to the port that
all the control units have, and it in turn makes the communication
ports available .
CIRCUIT BOARD DESCRIPTION
e
b
a
a Main RS232 port;
b USB port . A USB port is available for the connection of a PC to
carry out programming operations using the PxManager software . In
this case, the connection between control unit and PC is direct, and
can be made using a simple USB cable .
- During USB connection to the PC, or where there is an active PXWEB
connection, communication between the control unit and the BUS
KNX is suspended .
- The USB connection is not active where there are any PXWEB cards .
 KNX programming key and LED;
 BUS KNX terminal board;
e Second RS232 port: Connects the device to the control unit via the
PXWEB terminal board where present .
INSTALLATION
WARNING . In order for a safety event to be correctly posted by
the interface on the KNX bus, the minimum time of that event must be
greater than or equal to 3 seconds .
WARNING . For details about programming, contact technical
assistance .
WARNING . The device must only be installed by qualified
personnel, following the regulations in force and the guidelines for
KNX installations .
 