Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
System Test
System Test
1 .
Go into the Technical Menu .
(▲)/(▼)
2 .
With
select
SYSTEM
(▲)/(▼)
3 .
With
select
TEST
(▲)/(▼)
4 .
With
select the parts of the system that you want to
check and press (*) .
(#)
5 .
Press
to quit and go back to the previous menus .
Connecting PC – Control unit
Once the components of the system have been defined (previous
sections), you can move on to programming the control unit from
either a keypad or the PC via direct or remote connection .
Local programming via USB
Opening control unit
When the control unit is opened by removing the cover, the system
goes into alarm mode .
To avoid this, you must:
1 .
Go into the Technical Menu .
2 .
Open the control unit by undoing the relevant screws .
3 .
To prevent alarms being triggered at the end of programming
because of possible programming errors, we recommend put-
ting the control unit into maintenance mode . See also "START-
UP" section .
4 .
Put the control unit into maintenance mode, setting Dip 1 to
ON .
Connecting PC to control unit
1 .
Install the control unit programming software on your own PC .
2 .
Connect the control unit to the PC using a type A-B USB cable .
Settings on PC (to be done only once)
and press (*) .
and press (*) .
SYSTEM
SYSTEM 02
▼ ▲
*
TEST
▼ ▲
SYSTEM
*
INPUTS TEST
*=LAUNCH TEST
INPUTS CLOSED
#=ESC
C.U. TAMP. TEST
*=LAUNCH TEST
TAMPER CLOSED
#=ESC
C.U. BATT. TEST
*=LAUNCH TEST
C.U. BATTERY OK
#=ESC
1 .
On the PC set the password to access the control unit (the
same as the Technical Code 222222 which is factory-set) .
2 .
Select the COM communication serial port .
Set the programming mode on the Control unit (to be done only
once), choosing from
•
programming with control unit off
•
programming with control unit off after entering user
code
To set the desired mode, you must:
1 .
Go into the Technical Menu .
(
)/(
)
and press (*) .
2 .
With
select
CODES
▲
▼
(
)/(
)
3 .
With
select
INSTALLER
▲
▼
(
)/(
)
4 .
With
select
PROGRAM. FROM PC
▲
▼
(+)/(–)
5 .
With
change the parameter:
•
, direct programming without entering user
WITH CTL-U. OFF
code with control unit off .
•
, programming only after entering user code
AFTER USER CODE
with control unit off .
(#)
6 .
Press
to quit and go back to the previous menus .
CODES 16
*
TECHNICAL CODE
INSTALLER
*
PROGRAM. FROM PC
WITH CTL-U. OFF
BATTERY TEST XX
*=LAUNCH TEST
BATTERY ALXX OK
#=ESC
SIRENS TEST
*=LAUNCH TEST
ALARM OUTPUTS
-OFF- *=ON #=ESC
ALARM OUTPUTS
>ON< *=OFF #=ESC
and press (*) .
TECHNICAL CODE
.
▼ ▲
▼ ▲
▼ ▲
Publicité
Table des Matières
