Pxgprs; Circuit Board Description; Status Leds; Inserting Sim Card - CAME PXC48 Manuel Installateur

PXGPRS

Telephone dialler suitable for all Proxinet control units, complete
with stylus aerial . Allows SMS and voice messages to be sent and
SMS and DTMF commands to be received for remote control . Also
allows the security system to be managed remotely via the Came
Domotic APP and/or via TouchScreen Came and, when combined
with PIR Camera sensors, the VideoCheck to be managed .

CIRCUIT BOARD DESCRIPTION

f

a Connector for GSM aerial
b Connector for connection to Proxinet control unit board
 SIM slot
 Connector for connection of IGSM interface of control unit board
e LED status message
f Slot for micro SD card (provided) containing the module software
g Connectors for the connection of accessories PXDGETH/PXDG-
WF
 Connector for Touchscreen/Konnex interface
 Mounts
 Labels with the WiFi credentials (present even if accessory PX-
DGWF is not installed)

STATUS LEDS

On, Off, Flashing (2 flashes per second),
flash every 3 seconds), Rapid flashing (1 flash per second)
DL1 GREEN - Cloud connection
None
Connecting
Connected
DL2 RED - Internet connection
None
Connecting
Connected
a

e
g


b
Slow flashing (1
Status
Status
DL3 RED - Module on/off
GSM module off
GSM module on
DL4 GREEN - GSM modem
Off
GSM network not found
GSM network found
Connected to GSM network

INSERTING SIM CARD

All operations to insert and remove the SIM must be done with the
power off .
After having powered the control unit check that the GSM LED e
signals correct registration of the SIM .
The SIM-CARD (not included in the package) must have the follow-
ing characteristics:
- VOICE + SMS: incoming/outgoing calls and managing SMS,
- VOICE + SMS + DATA: connection to Cloud, sending mails for
videocheck,
- VOICE + SMS + MMS: sending MMS for videocheck .

INSTALLATION

PXDGWF
PXC48
PXC96
PXC200
PXDGWF
PXDGETH
With no power to the control unit, connect connector b of the mod-
ule to the control unit's CN1 connector, using the flat cable provided
and, if present, connect the accessories to the module using the
relevant connectors . Insert the SIM into the slot  .
Attach module PXGPRS to the control unit board using the mounts
provided in the package, taking care that the IGSM connector  is
correctly connected to connector CN2 .

SETTINGS

The device is detected automatically by the Control unit . To set up
the system refer to the control unit installer manual . To register the
device on CameConnect (www .cameconnect .net) refer to the rele-
vant manual .
Status
Status
PXGPRS