Balboa TP600 Manuel D'utilisation page 6

SAFETY WARNINGS
ensure that children are supervised at all times. Never leave children alone in the Spa. Take care
when entering and leaving the Spa to avoid slipping on wet surfaces.
• Do not allow anybody to play with sharp or metal objects inside the Spa, which could damage
the acrylic surface.
• Do not allow any user to access the electrical parts of the Spa.
• Do not start-up the Spa unless it is full of water.
• Do not use electrical or electronical apparatus inside the Spa.
• Do not let animals in the Spa.
• Do not fill the Spa with other liquid other than fresh, duly treated water.
• Do not fill the Spa with hot water (maximum 35ºC); let the water heat by itself, otherwise it could
damage the temperature probes (see "Temperature Adjustment").
• Do not use the Spa immediately after intense physical exercise.
• Do not use the Spa if you are suffering from a contagious disease or 14 days after recovering from
a contagious disease.
• In order to guarantee maximum safety when bathing all our Spas use pumps designed to suction
water from anti-vortex, safety drain covers, located on the floor of the Spa. Take special care that
these drain covers are not covered by any object or the users (pieces of clothing, hair, legs, etc.).
For safety reasons, your head should always be outside the Spa in order to avoid drowning. Do not
use the Spa if the drain covers are broken, damaged or unassembled, as apart from damaging the
Spa, it could also lead to a risk of drowning.
• The headrests of your Spa are made of synthetic foam, which can be damaged in high
concentrations or bromine or chlorine, or low levels of pH. Make sure that when adding chemical
products, the headrests are neither totally nor partially immersed in the water. If necessary,
remove them until the chemical products have taken effect. Damages resulting from improper
use shall not be considered under the guarantee of the product.
• The Spa includes a cover designed to protect the acrylic surface from sunrays when it is not being
used. This cover will also help to keep the water warm. and for sun protection that could damage
the acrylic material of the Spa. The cover will require .
• The appliance should be installed through a residual current device (RCD) with a rated tripping
current not exceeding 30 mA
• The floor has to be capable of supporting the expected load
The cover is designed to protect the spa, not to bear weight.
Not even water or snow.
Do not place objects on top of the cover
Do not allow people or animals get on the cover
Periodically remove snow to prevent buildup.
6 Spa for private use - Operating instructions