Balboa TP600 Manuel D'utilisation page 15

HOW TO USE YOUR SPA ENG
Dual Temperature Ranges (High vs. Low)
This system incorporates two temperature range settings with independent set temperatures. The
specific range can be selected on the Settings screen and is visible on the Main Screen in the upper
right corner of the display. These ranges can be used for various reasons, with a common use being
a "ready to use" setting vs. a "vacation" setting. Each range maintains its own set temperature as
programmed by the user. This way, when a range is chosen, the spa will heat to the set temperature
associated with that range.
High Range can be set between 80°F and 104°F / 27 ºC and 40 ºC..
Low Range can be set between 50°F and 99°F / 10 ºC and 37 ºC.
More specific Temp Ranges may be determined by the Manufacturer.
Freeze Protection is active in either range.
Heat Mode – Ready vs. Rest
In order for the spa to heat, a pump needs to circulate water through the heater. The pump that
performs this function is known as the "heater pump".
The heater pump can be either a 2-speed pump (Pump 1) or a circulation pump.
Rest Mode will only allow heating during programmed filter cycles. Since polling does not occur,
the temperature display may not show a current temperature until the heater pump has been
running for a minute or two.
Circulation Mode
If the spa is configured for 24HR circulation, the heater pump generally runs continuously. Since
the heater pump is always running, the spa will maintain set temperature and heat as needed in
Ready Mode, without polling.
In Rest Mode, the spa will only heat to set temperature during programmed filter times, even
though the water is being filtered constantly when in 24HR circulation mode.
Ready-in-Rest Mode
Ready in Rest Mode appears in the display if the spa is in Rest Mode and the Jets 1 Button is
pressed. After 1 hour, the System will revert to Rest Mode. This mode can also be reset by selecting
the Heat Mode line on the Screen shown here.
15