Balboa TP600 Manuel D'utilisation page 13

HOW TO USE YOUR SPA
Pre-set filter cycles TP600 Control Panels
Main Screen
To next item in
Main Menu
Purge Cycles
In order to maintain sanitary conditions, as well as protect against freezing, secondary water
devices will purge water from their respective plumbing by running briefly at the beginning of
each filter cycle. (Some systems will run a certain number of purge cycles per day, independent of
the number of filter cycles per day. In this case, the purge cycles may not coincide with the start
of the filter cycle.)
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter Cycle 2 will initiate a purge when
Filter Cycle 2 is programmed to begin.
The Meaning of Filter Cycles
1. The heating pump always runs during the filter cycle*
2. In Rest Mode, heating only occurs during the filter cycle
3. Purges happen at the start of each filter cycle
* For example, if your spa is set up for 24/hour circulation except for shutting off when the water temperature is
3˚F/1.3˚C above the set temperature, that shutoff does not occur during filter cycles.
While the Temperature is
still flashing, press Light
repeatedly until MODE
appears in the LCD.
Shows/flashes start time
to show RUN HRS
to show F1 ENDS xx:xx
To Set
Waiting
To Set
Several Seconds
Reverts to Original Setti
*****
Shows/flashes start time
to show RUN HRS
to show F1 ENDS xx:xx
Sets start hour Selects minutes
Sets Filter 1 length in hours Selects part of an hour
To Set
*****
Waiting several seconds
will lose any new Filter 1
Start Time and Run Hours and
revert to the previous Filter 1 settings.
Main Screen
ng
To Set
Sets start hour Selects minutes
Sets Filter 1 length in hours Selects part of an hour
To Set
*****
Waiting several seconds
will lose any new Filter 2 On/OFF,
Start Time and Run Hours and
revert to any previous Filter 2 settings.
ENG
Waiting
Sets 15-minute
Several Seconds
increments
Reverts to Original
ng
Setti
*****
Sets 15-minute increments
Wait to
Revert
*****
Waiting
Sets 15-minute
Several Seconds
increments
Reverts to Original
ng
Setti
*****
Sets 15-minute increments
*****
Main Screen
Main Screen
13