Balboa TP600 Manuel D'utilisation page 16

HOW TO USE YOUR SPA
ADJUSTING FILTRATION
Main Filtration
Using the same adjustment as Setting the Time, Filter Cycles are set using a start time and a
duration. Each setting can be adjusted in 15-minute increments. The panel calculates the end time
and displays it automatically.
Filter Cycle 2 - Optional Filtration
Filter Cycle 2 is OFF by default. Press "1" to view Filter 1. Press "2" once to view Filter 2. Press "2"
again to turn Filter 2 ON or OFF. When Filter Cycle 2 is ON, it can be adjusted in the same manner
as Filter Cycle 1. It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall
filtration by the overlap amount.
Purge Cycles
In order to maintain sanitary conditions, as well as protect against freezing, secondary water
devices will purge water from their respective plumbing by running briefly at the beginning of
each filter cycle. (Some systems will run a certain number of purge cycles per day, independent of
the number of filter cycles per day. In this case, the purge cycles may not coincide with the start
of the filter cycle.)
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter Cycle 2 will initiate a purge when
Filter Cycle 2 is programmed to begin.
Restricting Operation
The control can be restricted to prevent unwanted use or temperature adjustments.
Locking the Panel prevents the controller from being used, but all automatic functions are still
active. Locking the Settings allows Jets and other features to be used, but the Set Temperature
and other programmed settings cannot be adjusted.
Settings Lock allows access to a reduced selection of menu items. These include Set Temperature,
Invert, Lock, Utilities, Information and Fault Log. They can be seen, but not changed or edited.
16 Spa for private use - Operating instructions