Artromot®-S Description; Description Of The Device Components - DJO Global ARTROMOT-S3 Série Mode D'emploi

. ARTROMOT®-S description
The motorized CPM device supports the
following movements of the shoulder joint:
Adduction/abduction
Internal/external rotation 90° - 0° - 90°
Elevation (flexion)
with elbow bent between
Horizontal
adduction/ abduction
(manual adjustment only)
It can be reconfigured for use on either side.
Note!
To allow the current position of the
CPM device to be clearly indicated, the
internal rotation values on the display
and throughout this document are
identified with "-".
These are some of the outstanding
ARTROMOT®-S features:
– anatomically correct setup
– physiological movements
– maximum possible ranges of motion
– programming unit for precise adjust-
ment of patient-specific therapy values
– chip card for storage of the programmed
therapy parameters
– easy transport
Biocompatibility
Those parts of the ARTROMOT®-S device
that come into contact with the patient
when the device is used as intended, are
designed to fulfil the biocompatibility re-
quirements of the applicable standards.
. Description of
the device components
Note:
Please fold out page ΙΙΙ !
0° - 30° - 175°
0° - 30° - 175°
60° and 90°
0° - 120°
Subject to technical modifications
(06/2007)
_________________
¹ Only with ARTROMOT®-S comfort
1. Programming unit
2. Patient chip card
3. Compartment for storage of
programming unit
4. Armrest for healthy arm
5. Wheels
6. Connection for power cord
7. Power switch (ON/OFF)
8. Instrument fuse
9. Connection for motion element
10. Thumbscrew for adjustment of the
backrest angle
11. Folds down the backrest
(transport position)
12. Adjustment for horizontal
adduction/abduction
13. Holding tube for height adjusment
14. Locking screw for height adjustment
15. Insertion tube for height adjustment
16. Motor A
17. Holding tube for length adjustment
(upper arm)
18. Clamping lever for length adjustment
(upper arm)
19. Insertion tube for length adjustment
(upper arm)
20. Locking screw for elbow range
21. Motor B
22. Elbow support
23. Forearm support
24. Strap for forearm restraint
25. Holding tube for length adjustment
(forearm)
26. Clamping lever for length adjustment
(forearm)
27. Insertion tube for length adjustment
(forearm)
28. Locking screw for swivel mechanism
29. Handle
30. Headrest adjustment¹
31. Height adjustment for
shoulder restraint¹
32. Height adjustment for
shoulder restraint¹
33. Ball joint for headrest¹
34. Locking pin