Description Of The Artromot®-E2/-E2 Compact - DJO Global ARTROMOT-E2 Mode D'emploi

2. Description of the ARTROMOT®-E2/-E2 compact
The motorized CPM device supports the
following movements of the elbow joint:
Extension/flexion 5° - 0° - 140°
Pronation/supination
90° - 0° - 90°
it can be reconfigured for use on either
side.
Note!
To unambiguously represent the current
position of the CPM device, pronation
and extension values below 0° are
marked with the symbol "-" both on
the dis play and in this document.
These are some of the outstanding
ARTROMOT®-E2/-E2 compact features:
− anatomically correct setup
− physiological movements
− maximum possible ranges of motion
− programming unit for precise adjust-
ment of patient-specific therapy values
− chip card for storage of the programmed
therapy parameters
− easy transport
Biocompatibility
Those parts of the ARTROMOT®-E2/-E2
compact that come into contact with
the patient when the device is used as
intended, are designed to fulfil the biocom-
patibility requirements of the applicable
standards.
50
2.1 Description of the
ARTROMOT®-E2
device components
Note: See device description on pages
II and III
1. knob for horizontal adduction/
abduction (horizontal extension/
flexion)
2. screw for double joint
3. double joint
4. screw for height adjustment
5. upper arm support
6. locking pin for height adjustment
of upper arm support
7. screw for elbow angle adjustment
8. Cam lever for forearm length
adjustment
9. slider
10. screw for adjustment of the
backrest angle
11. Pin for swivel motion of upper
arm support
12. screw for forearm module
swivel motion
13. locking screw for right/left
positioning
14. Armrest for healthy arm
15. Programming unit
16. Compartment for storage
of programming unit
17. Patient chip card
18. Connection for power cord
19. Power switch (On/OFF)
20. Fuse
21. Connectors for motion element
22. locking pins
23. straps for forearm support
24. Motor A
25. Motor b
26. Palmar hand support
27. dorsal hand support
28. Folds down the backrest
(transport position)
29. wheels
30. bracket for adjustment of
the positioning angle
31. strap for upper arm support
32. Connector for programming unit
subject to technical modifications
(07/2008)
51
2.2 D escription of the
ARTROMOT®-E2 compact
device components
Note: See device description on pages VIII
and IX
1. screw for height adjustment
2. screw for elbow angle adjustment
3. Cam lever for forearm length
adjustment
4. slider
5. Pin for swivel motion of upper
arm support
6. screw for forearm module swivel
motion
7. locking screw for right/left positioning
8. Fuse
9. Connectors for motion element
10. straps for forearm support
11. Motor A
12. Motor b
13. Palmar hand support
14. dorsal hand support
15. Programming unit
16. Connector for programming unit
17. Patient chip card
18. Connection for power cord
19. Power switch (On/OFF)
20. upper arm support
21. strap for upper arm support
22. wheel locks
23. Compartment for storage of
programming unit
24. locking screw
25. wheels
26. Pin for height adjustment of upper
arm support
27. bracket for adjustment of the
positioning angle
subject to technical modifications
(07/2008)