DJO Global ARTROMOT-S3 Série Mode D'emploi page 73

n Stretching in abduction
With the special „Stretching in abduc-
tion" function the carriage gently
stretches the joint by lifting the arm.
Only the abduction movement is treated
here. Motor B is automatically disabled.
The position of motor B cannot be
changed once this special function has
been activated.
Starting at the middle position the car-
riage will first move to the programmed
adduction position and then to the
programmed abduction position.
Subsequently the carriage reverses 5°
towards adduction and then moves very
slowly back again to the programmed
abduction position (display
After that it attempts to attain another
5°, moving even slower than before
(display ).
If a high resistance toward the ad-
ditional 5° is sensed, the reverse on
load function is automatically activated
and the carriage moves in the opposite
direction.
This stretch cycle is repeated ten times.
After that the carriage moves to the
programmed maximum adduction posi-
tion and restarts the abduction stretch
cycle.
This sequence can be repeated as often
as needed. You can stop treatment
with the STOP key; after the pro-
grammed therapy duration, it will stop
automatically.
Default: disabled
Note!
– If a pause is programmed when you
enable the function, the carriage will
stop for the duration of the pause
each time the maximum stretching
value is attained.
– Enabling the stretching in abduction
function automatically disables mo-
tor B. The only movement performed
is adduction / abduction.
– It is not possible to combine a second
stretching function with the special
function „stretching in abduction".
– During operation, the display
will show the symbol
in the upper, left-hand corner.
n Stretching in internal rotation
With the special „Stretching in internal
rotation" function the carriage gently
stretches the joint towards the inside.
Starting at the middle position the car-
riage will first move to the programmed
external rotation position and then
to the programmed internal rotation
position.
Subsequently the carriage reverses 5°
towards external rotation and then
moves very slowly back again to the
programmed internal rotation position
(display
attain another 5°, moving even slower
than before (display
).
If a high resistance toward the
additional 5° is sensed, the reverse on
load function is automatically activated
and the carriage moves in the opposite
direction.
This stretch cycle is repeated ten times.
After that the carriage moves to the
programmed maximum external rota-
tion position and restarts the internal
rotation stretch cycle.
This sequence can be repeated as often
as needed. You can stop treatment
with the STOP key; after the pro-
grammed therapy duration, it will stop
automatically.
Default: disabled
Note!
– If a pause is programmed when you
enable the function, the carriage will
stop for the duration of the pause
each time the maximum stretching
value is attained.
– Enabling the stretching in internal
rotation function automatically dis-
ables motor A.
The only movement performed is
internal / external rotation.
– It is not possible to combine a second
stretching function with the special
function „stretching in internal
rotation".
– During operation, the display will
show the symbol
left-hand corner.
). After that it attempts to
).
in the upper,