Adjustment Mode - SORHEA SOLARIS Notice D'installation

SORHEA
 Adjustment mode
Rules to follow:
1. The alignment consists in finding the position that gives the maximum signal for the
minimum power (power potentiometer of the beam).
2. The TX and RX columns must both be in alignment mode.
3. The beam number in alignment mode must be the same on both columns.
Alignment of barrier 2.5 m / 8.2 ft or 3 m / 10 ft:
 Put in alignment the bottom control board to align the cells connected to it and switch off
the top control board with the jumper pin ON-OFF on both columns forming the barrier
(TX and RX).
 Put in alignment the top control board to align the cells connected to it and switch off the
bottom control board with the jumper pin ON-OFF on both columns forming the barrier
(TX and RX).
Signal
Adjustment of the transmission power
(only active while in alignment mode)
max. signal
Position
Red LED
Select
push button
- 43 -
SOLARIS