Channel Selection; Alignment And Adjustment; Optical Alignment - SORHEA BIRIS II 50 Notice D'installation

SORHEA
4

CHANNEL SELECTION

To prevent interference by one barrier with another on the same site, barriers are equipped with four
selectable frequencies (channels).
The receiver and its associated transmitter must be configured with the same channel number. This
configuration is performed by using switches 3 & 4 on the control unit. The channel is confirmed by
the receiver and the transmitter when the barrier's power is turned on. (Once the barrier's power is
turned on, the channel selection switches have no effect when operated.)
ALIGN. CHANNEL
1 2
.
When barriers are stacked (fig. 1) or installed along the same line (fig. 2), select a different channel
for each barrier.
Transmitter
Transmitter
CHANNEL 1
Transmitter
5

ALIGNMENT AND ADJUSTMENT

The alignment is comprised of two phases: the first is comprised of an optical alignment; the second
is comprised of an optimizing phase for the receiver for the models BIRIS II 50 and 100 and for the
receiver and transmitter for the BIRIS II 200.

Optical alignment

Transmitter
Switch 3 & 4 :
channel selection
RX
3 4
CHANNEL 1
ON
OFF
Receiver Receiver
3 4 3 4
CHANNEL 2 CHANNEL 3
fig.1
CHANNEL 2
CHANNEL 1
fig. 2
CHANNEL 2
Transmitter Transmitter
Optical axis
- 24 -
BIRIS II 50/100/200
ON
3 4 3 4
CHANNEL 4
Receiver
Receiver
CHANNEL 3
Receiver
Receiver