Channel Selection - SORHEA BIRIS II 50 Notice D'installation

SORHEA

wire
0,6 mm / 0.02 in
0,9 mm / 0.4 in
1,4 mm / 0.06 in
1,8 mm / 0.07 in
2,3 mm / 0.09 in
T = Transmitter
Note: When using the same cable to supply power to several components, the indicated distances are
divided by the number of connected components.
When using several wires with the same section in parallel by polarity, the indicated distances are
multiplied by the number of connected wires.
Alarm and disqualification relay (BIRIS II 100 and BIRIS II 200)
Signal
Min
4sec.
Signal
Note: for the BIRIS II 50, the intrusion relay remains in the event of a prolonged or disqualifying
alarm.
4

CHANNEL SELECTION

To prevent interference by one barrier with another on the same site, barriers are equipped with four
selectable frequencies (channels).
The receiver and its associated transmitter must be configured with the same channel number. This
configuration is performed by using switches 3 & 4 on the control unit.
The channel is confirmed by the receiver and the transmitter when the barrier's
power is turned on. (Once the barrier's power is turned on, the channel selection
switches have no effect when operated.)
LENGTH OF HEATER CABLES 12 V AC-DC
(Wire type STY1 shielded)
Wire section
0,3 mm² / 23 AWG
0,6 mm² / 20 AWG
1,5 mm² / 16 AWG
2,5 mm² / 14 AWG
4 mm² / 12 AWG 500 m / 0.31 mi 500 m / 0.31 mi 250 m / 0.16 mi
R = Receiver
Max 60sec.
BIRIS II 50 / BIRIS II 100 / BIRIS II 200
T
40 m / 0.02 mi 40 m / 0.02 mi
85 m / 0.05 mi 85 m / 0.05 mi
190 m / 0.12 mi 190 m / 0.12 mi 95 m / 0.06 mi
300 m / 0.19 mi 300 m / 0.19 mi 160 m / 0.1 mi
T+R = complete barrier (transmitter + receiver)
Interruption of the beam
Alarm relay
Interruption of the beam
Alarm relay
Disqualification relay
- 24 -
BIRIS II 50/100/200
R T+R
20 m / 0.01 mi
40 m / 0.02 mi