Installation - SORHEA BIRIS II 50 Notice D'installation

SORHEA
3

INSTALLATION

For wall mounted installations, use the provided screws and lag shields.
Drill 4 holes and install the lag shields using the template below:
Screw covers
Open the 4 screw covers
to mount the column.
Removal / Reinstallation of the infrared cover
Unscrew the 2 screws fastening the infrared cover and remove them.
Position the infrared cover on the plate then screw in the two fastening screws.
2 M4 mounting screws
Cable routing in the barrier
Passage of the screw
Cable
(*)
- 21 -
BIRIS II 50 47 mm / 1.85 in 315 mm / 12.4 in
BIRIS II 100 65 mm / 2.6 in 367 mm / 14.5 in
BIRIS II 200 65 mm / 2.6 in 367 mm / 14.5 in
Wire race
1. Break the hole and insert
the cable into the wire
race, leaving some slack.
2. Wire the column.
3. Bring out the cable as
indicated (*).
BIRIS II 50/100/200
X
X Y