Installation Instructions; Installation - Vented To The Outside; Step 1. Ductwork, Wiring Locations; Step 2. Wall Or Ceiling And Cabinet Preparation - GE Monogram ZV30H Instructions D'installation

INSTALLATION – VENTED TO THE OUTSIDE
1
DUCTWORK, WIRING LOCATIONS
Determine the exact location of the vent hood.
• Locate the template packed with the literature.
– Measure 36" from the floor to the top of the cook-
ing surface. Add hood installation height deter-
mined on previous pages. Mark that location.
– Use a level to draw a straight pencil line on the wall.
– Tape the template in position along the penciled
line. CHECK TO BE SURE THE TEMPLATE IS LEVEL.
6 5/8"
Centerline 8 1/4" min.
above hood chassis
31-10750
02-10 GE
Cabinet/Ceiling ducting:
If ductwork will vent straight up to the ceiling or
cabinet:
• Use a level to draw a line straight up, from the cen-
terline on the template to the ceiling/cabinet.
• Measure 6-5/8" from the back wall to the centerline
of an 8-1/2" hole on the ceiling/cabinet top.
NOTE: If drywall is not present, add drywall thickness
to the 6-5/8" dimension.
Wall Ducting:
If ductwork will vent to the rear:
• Use a level to draw a line straight up from the
centerline on the template.
• Measure at least 8 1/4" above the hood chassis
top surface location shown on the template to the
centerline of a 8-1/2"-dia. duct hole. (Hole may be
elongated for duct elbow.)
House Wiring Location:
• The junction box is located on the top right side of
the hood.

Installation Instructions

8-1/2" diam.
hole for duct
Sup # 270-025
1
DUCTWORK, WIRING LOCATIONS
(Continued)
• Wiring can enter the cabinet from the ceiling or
back wall.
• Route additional wiring length to reach the junction box.
2 WALL OR CEILING AND CABINET
PREPARATION
IMPORTANT —
to the cabinet and at least two wall studs and
drywall with anchors. Cabinet must be capable of
supporting 100 lbs.
• With the template taped in place, use a punch to
mark all mounting screw locations. Mark duc-
twork, screw and electrical holes according to
your application.
• Drill a minimum 3/4" hole for electrical cable in
the bottom of the cabinet.
• Drill 1/8" pilot holes at the 4 punched locations on
the bottom of the cabinet.
• Drill 1/8" pilot holes at the 4 punched locations on
the wall
• Remove the template.
• Enlarge holes that did not enter studs to 5/16".
Tap anchors for wall fasteners into the holes.
Cabinet template
REFERENCE - RISER PANEL TOP SURFACE
REFERENCE - CHASSIS TOP SURFACE
PILOT HOLES DRILL 1/8" FOR STUDS
13-3/8"
PILOT HOLES 5/16" FOR ANCHORS
31-10750
BOTTOM OF THE HOOD
02-10 GE
Wall template
NOTE: It is important to engage the wall
studs with at least two screws. Use the
holes which align with the studs.
10
The vent hood must be secured
Cabinet mounting
screw locations
7-1/16"
WALL MOUNTING HOLES
IT IS IMPORTANT TO ENGAGE
WALL STUDS WITH AT LEAST
TWO SCREWS. USE HOLES
THAT ALIGN WITH STUDS.
Sup # 270-025
Wall mounting
screw locations