Safety Information; Before You Begin; Important - GE Monogram ZV30H Instructions D'installation

READ AND SAVE THESE INSTRUCTIONS

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT

•
for local inspector's use.
IMPORTANT
•
codes and ordinances.
Note to Installer
•
instructions with the Consumer.
Note to Consumer
•
tions with your Owner's Manual for future reference.
Skill Level
• — Installation of this appliance re-
quires basic mechanical and electrical skills.
Completion Time
•
• Proper installation is the responsibility of the in-
staller. Product failure due to improper installation
is not covered under the warranty.
For Monogram local service in your area, call 1.800.444.1845.
For Monogram service in Canada, call 1.800.561.3344.
For Monogram Parts and Accessories, call 1.800.626.2002.
CAUTION:
Due to the weight and size of
these vent hoods and to reduce the risk of personal injury
or damage to the product, TWO PEOPLE ARE REQUIRED
FOR PROPER INSTALLATION.
WARNING:
electrical shock, do not use this range hood with any
external solid-state speed control device. Any such
alteration from original factory wiring could result in
damage to the unit and/or create an electrical safety
hazard. TO REDUCE THE RISK OF FIRE, USE ONLY METAL
DUCTWORK.

Safety Information

— Save these instructions
— Observe all governing
— Be sure to leave these
— Keep these instruc-
— 1 to 3 Hours.
To reduce the risk of fire or
WARNING:
FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the
manufacturer. If you have any questions, contact
the manufacturer.
B. Before servicing or cleaning the unit, switch the
power off at the service panel and lock the service
disconnecting means to prevent the power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag,
to the service panel.
CAUTION:
USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS
MATERIALS, EXPLOSIVE MATERIALS OR VAPORS.
WARNING:
ELECTRICAL SHOCK OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
• Installation work and electrical wiring must be done
by qualified person(s) in accordance with all ap-
plicable codes and standards, including fire-rated
construction.
• Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent back-drafting.
Follow the heating equipment manufacturer's
guidelines and safety standards, such as those
published by the National Fire Protection Associa-
tion (NFPA), the American Society for Heating, Re-
frigeration and Air Conditioning Engineers (ASHRAE)
and the local code authorities.
• When cutting or drilling into walls or ceilings, do not
damage electrical wiring and other hidden utilities.
• Ducted systems must always be vented to the out-
doors.
• Local codes vary. Installation of electrical connections
and grounding must comply with applicable codes.
In the absence of local codes, the vent should be in-
stalled in accordance with National Electrical Code
ANSI/NFPA 70-1990 or latest edition.
CAUTION:
properly exhaust air, be sure to duct air outside—do not
vent exhaust air into spaces within walls or ceilings or into
attics, crawl spaces or garages.
2
TO REDUCE THE RISK OF
FOR GENERAL VENTILATING
TO REDUCE THE RISK OF FIRE,
To reduce risk of fire and to