Maintenance And Inspection Table; Decommissioning; Warranty - CEMO 60 Mode D'emploi

GB

6.2 Maintenance and inspection table

Interval
As required
Monthly
Monthly
Annually
Annually, or more
frequently if needed
Tyre pressure of the transport wheels for the 95 l version 2 bar.
You will find details for cleaning the inlet strainer in the pump
instructions in the chapter "Cleaning the inlet strainer".
You will find details for troubleshooting pump-related issues in
the pump instructions in the chapter "Troubleshooting".
m
m Filling pipe with KITO
elements for filling (13.1) and venting (13.2)
Remove anti-twist mechanism
Remove filling pipe
m
arrester elements 13.1 and 13.2 with com-
pressed air. Do not, under any circumstances,

7. Decommissioning

the filling station
• First, drain the tank completely (by means of
the pump via the delivery hose and delivery
nozzle while in a horizontal position).
Next:
• Disassemble the petrol trolley into its constitu-
ent parts, sort by material and dispose of in
accordance with local regulations.
Risk
of environmental contamination
through residues in the tank. Collect
these residues separately and dis-
pose of them in compliance with
local environmental regulations.
22
Assembly
Outside of filling station
Container
Piping system
Filter
KITO flame arrester
®
elements
13.1
13.2
flame arrester
®
.
l
, blow out KITO flame
®
Action
Remove any dirt
Visual check for damage
Check hoses for cracks and porosity,
check fittings for leaks (replace defective parts)
Clean
Blow out the elements with compressed air.
remove the flame arrester. Check for damage
caused by corrosion, mechanical loads or
tarnishing, and for loose and slipping strip coils
as a result of flashbacks.
- If there is visible dirt on the elements 13.1
and 13.2 which cannot be blown out, or if they
are damaged, the whole filling pipe
be replaced as otherwise the filling speed will
be reduced, in which case the flame arrester
function is no longer guaranteed.
If a flashback has occurred, the whole fuel
trolley must be checked and the KITO
in the filling pipe replaced.

8. Warranty

Under our general terms and conditions of trade
we warrant that the equipment will be produced
free from defects in materials, functionality or
workmanship.
These can be inspected at
http://www.cemo.de/agb.html
The warranty applies only under the condition
that the above operating and maintenance
instructions and all applicable regulations are
closely followed.
Modification of the filling station by the customer
without consultation with the manufacturer
CEMO GmbH invalidates any claims under the
statutory warranty.
CEMO GmbH also accepts no responsibility for
damage caused by inappropriate use.
must
m
elements
®