Initial Setup - CEMO 60 Mode D'emploi

GB

4. Initial setup

1. Remove the transport tie-down (red tie-wrap)
of the delivery nozzle and the instructions.
The stickers and screws for both the 60 litre and
the 95 litre versions are enclosed in the flat bag.
2. 60 litre version
Permanently affix the "Hazard label with
UN1203" from the supplied tank documentati-
on on the front side
3. 95 litre version
Affix the stickers enclosed with the tank
documents permanently to the front panels.
Fasten both hose holders to the tank
using the 6 enclosed M6x10 screws.
18
Hazard label
with UN 1203
Hazard label
UN 1203
4. Place petrol trolley in a horizontal position.
Before opening the filling lock a , make a
conductive connection with the cable with
battery pole terminals and earthing terminal
h between the tank and the transport vehicle
or the ground.
Open screw cap a .
Filling the tank.
i
Important!
Avoid sources of ignition, such as
smoking or naked flame.
Warning: Risk of explosion.
Please always use an automatic
delivery nozzle to avoid overflows.
Hold the delivery nozzle in the filling
opening. Do not use an extension.
5. Perform a test filling as described in section
5.6, but hold the delivery nozzle in the still
open filling opening.
6. Close the filling opening with the screw cap.
Disconnect cable with battery pole terminals
and earthing terminal h from the transport
vehicle or from the ground, wind it up and fix the
terminal clamp to the point provided.
The filling station is now ready for operation.