Sartorius Stedim Biotech arium 61316 Mode D'emploi page 9

Display Installation
The display unit has been designed
to be mounted in 3 ways:
At the top of the right door for
bench systems, at the bottom of
the right door for wall-mounted
systems or in a remote location
up to 2.8 m from the system
(additional kit required).
To install:
– Route the supplied cables through
the large opening of the right door
(top or bottom).
– Use the 4 screws and washers
provided to mount the display unit
on the door by routing the screws
from inside the door through the
holes in the door to the outside and
screw to the assembly.
– Connect the data and power cord
of the display to the plug-in, inside
the system.
Follow the course of dotted lines
in the figure:
Position 1 for top mounted display
Position 2 for bottom mounted
display
– Place rubber cover over the
remaining recess (top or bottom)
in the doors.
Mounting the display on the top
Mounting the display on the bottom
9