Operating The Hedge Trimmer - Stihl HSA 56 Notice D'emploi

10 Operating the Hedge Trimmer

► If the switch lever is stiff or does not spring back to its idle
position: Contact your STIHL servicing dealer.
The switch lever has a malfunction.
Switching On
► Fit the battery.
► Depress the switch lever and release it again.
► If the cutting blades have run or are running: Contact your
STIHL servicing dealer.
The trigger has a malfunction.
► Depress the trigger lockout and hold it in that position.
► Pull the trigger and hold it there.
► If the cutting blades run: Contact your STIHL servicing
dealer.
The switch lever has a malfunction.
► Depress the switch lever (1) and hold it in that position.
The cutting blades run.
► If 3 LEDs flash red: Remove the activation key and contact
your STIHL servicing dealer.
There is a malfunction in the hedge trimmer.
► Release the switch lever.
The cutting blades stop running after about 1 second.
► If the cutting blades continue to run after 1 second:
Contact your STIHL servicing dealer.
Your hedge trimmer has a malfunction.
10 Operating the Hedge Trimmer
10.1 Cutting
► Use lopping shears or a chain saw to cut out thick
branches first.
0458-714-9621-B
All manuals and user guides at all-guides.com
► Hold the hedge trimmer with one hand on the control
► Hold the hedge trimmer with the other hand on the loop
► Starting at one side of the hedge, swing the hedge trimmer
► Lower the nose of the hedge trimmer.
► Walk slowly and steadily forwards.
► Again swing the hedge trimmer from the bottom upwards
► Cut the other side of the hedge.
► Hold the cutting blades at an angle of 0° to 10° to the top
► Swing the hedge trimmer back and forth horizontally in an
handle – wrap your thumb around the control handle.
handle – wrap your thumb around the loop handle.
from the bottom upwards in an arc.
in an arc.
of the hedge as you swing the hedge trimmer horizontally.
arc.
The cuttings fall to the ground.
English
0-10°
43