Checking And Setting The Linkage Rods - Reely SKY Thunder 500 ARF Notice D'emploi


10. Adjustments, Setup
For checking all settings, the helicopter must be programmed on your remote control ready to fly. For this, observe all
notes from the operating instructions of the remote control, gyro and speed controller.
Your new helicopter model already has mechanic basic settings for the swash plate at delivery. The following notes are
only for verification and may also help for maintenance or repairs.
a) Checking and Setting the Linkage Rods
For the required lengths of the individual rods (numbers in figures 13a and 13b), refer to the diagram below.
Lengths are stated from outer ball
head edge to outer ball head edge and
thus constitute the mechanic basic
settings of the swash plate link.
Figure 13a (Rods present 2x each):
1 Fixed
2 Fixed
3 Length 60.5 mm (pitch compensation)
Figure 13b (Rods present 1x each):
1 Length 57.5 mm (pitch)
2 Length 67.5 mm (left rolling)
3 Length 67.5 mm (right rolling)
All manuals and user guides at all-guides.com
Figure 13a
Figure 13b
49