Putting Out Of Operation - Abicor Binzel ADF 600S Mode D'emploi

ADF 600S
7 Operation
Arc eye
Welding with a faulty ADF 600S can damage the eyes.
• Immediately stop welding work with the ADF 600S and resolve the malfunctions that occurred.
• Only use an intact ADF 600S.
• Adjust the ADF 600S to your head size.
Risk of injury
Injuries may be caused by impact from particles travelling at high speed.
• Wear standard safety goggles under the ADF 600S.
• Only use the ADF 600S as protection against high-speed particles at room temperature.
NOTICE
• Ensure the proper seating of the ADF 600S.
• Test the seating of the ADF 600S regularly by lifting and reseating the ADF 600S. If the head band
• For the welding process, please consider all components that are included in the welding system.
• The ADF 600S may only be operated by qualified personnel (in Germany, see TRBS 1203).

8 Putting out of operation

NOTICE
• When putting the system out of operation, ensure that the procedures for switching off each of the
• When the welding process is interrupted or completed, wait until the automatic filter switches from
All manuals and user guides at all-guides.com
WARNING
 Tab. 11 Troubleshooting on page EN-18
 6 Putting into operation on page EN-9
WARNING
slips in the process, adjust the settings for head circumference and head height.
 6 Putting into operation on page EN-9
welding system components are observed.
dark to light depending on the pre-set delay time. Only then, remove the ADF 600S.
7 Operation
EN - 15