CAME PXC99W Manuel De Programmation page 48

Balancing
BALANCING
SINGLE BAL.
To change the balancing of the input
For radio inputs there is no programming of balancing The
settings of the wired inputs on the radio device are done using the
dipswitch on the device
Radio-type input Only parameter available for radio-type
RADIO
inputs, and not available for wired inputs
Input normally closed
NORM.CLS
Input normally open
NORM.OPN
Input with single balancing
SINGLE BAL.
Input with double balancing
DOUBLE BAL.
When an input of this type is enabled, the pa-
SHUTTER VIBRATION
rameters and
PULSES NO. PULSES TIME
See also "Inputs cabling" in the Installer Manual
Radio channel
RADIO CHANNEL XXX
[1..03] NUMBER 03
To change the radio channel associated with the input
Parameter visible only for radio inputs
Example: the radio magnetic contact has 3 channels:
1. Input 1.
2. Input 2.
3. Magnetic contact.
Radio device learning
LEARN
*=OK #=ESC
To associate a radio device with an input
Parameter visible only for radio inputs
Radio supervision
SUPERVISION
NO
To activate a technical alarm if an "up and running" signal is not
received from a radio device for longer than the time set in SUPER-
VISION TIME
Parameter visible only for radio inputs
Videocheck
VIDEO CHECK
NO
To enable/disable the videocheck on the selected sensor
Photo format
PHOTO FORMAT
VGA/QVGA
To configure the format of the image acquired
The video is available only in QVGA format
001
(+)/(‒)
are displayed
(+)/(‒)
001
(*)/(#)
001
(*)/(#)
001
(*)/(#)
001
(*)/(#)
Interframe
INTERFRAME
500MS
If the sensor is configured as "Series of photos", it is possible to set
the gap between two photos with this parameter
For QVGA photos the values that can be set are:
500ms/1000ms/1500ms/2000ms
For VGA photos the values that can be set are:
1000ms/2000ms/3000ms/4000ms
Number of frames
NUM. FRAME
[1...10]
To set the number of frames to acquire (Photo Mode)
Video duration
VIDEO DUR.
[S] [2...20]
To set the duration of the video to acquire (Video Mode)
Acquisition
MODE
PHOTO/VIDEO
To set the type of acquisition: (Photo) Sequence of photos or videos
Number of pulses
NUM. PULS.
[1..15] NUMBER 03
To choose the number of pulses to receive in the time set in
, to trigger an alarm
PULSES TIME
Parameter visible only for shutter or inertia type inputs
Pulses time
PULS. TIME
[1..255] SEC 03
To set the pulses time within which to receive the pulses selected
in , to trigger an alarm
PULSES NO.
Parameter visible only for shutter or inertia type inputs
Associated areas
AREAS
#-------
To associate the input with one or more areas
The behaviour of an input associated with more than one area de-
pends on the value selected for parameter
001
(▲)/(▼)
500ms
1000ms
1500ms
.....
001
(*)/(#)
001
(*)/(#)
001
(*)/(#)
001
(*)/(#)
001
(*)/(#)
001
(1)....(8)
AND/OR AREAS