Troubleshooting/Repair - Nikon MONARCH 7i VR Manuel D'utilisation

￭ Troubleshooting/Repair
If the Nikon Laser Rangefinder fails to function as expected, check the list below before consulting
your local dealer or the store where you purchased it.
● If there is a problem with the product.
Problem
・Does not turn on
・Unable to measure
・Anomalous result
・Do not know if the VR
(Vibration Reduction)
function is working
・ Cannot turn off the VR
(Vibration Reduction)
function
・There are minute motion
sounds when the power
turns on and off
・[ ] is displayed in the
internal display
All manuals and user guides at all-guides.com
・Press the PWR button (top of the body).
・Check battery is inserted correctly.
・Replace the battery with a new one.
・Confirm each mode setting.
・Confirm if it can measure a large target close to you (example: a building
approx. 15 m/yd. ahead of you).
・Clean the lens surface if necessary.
・Compare the vibration of the target in the viewfinder when the Laser
Rangefinder is ON and OFF.
・ While the Laser Rangefinder is ON, the VR (Vibration Reduction) function is
always activated.
・The VR (Vibration Reduction) function is activated concurrently when
the Laser Rangefinder is ON. When the Laser Rangefinder is OFF, the VR
(Vibration Reduction) function automatically turns off.
・The VR (Vibration Reduction) function cannot be switched on and off.
・Due to the VR (Vibration Reduction) system motor, minute motion
sounds occur. These sounds are normal, please continue to use the Laser
Rangefinder.
・ Failure indication. Please contact your local dealer or the store where you
purchased the product.
Cause/Solution
En
Es
Fr
Pt
21