Restoring Factory Settings; Troubleshooting - Esoteric Grandioso P1X Mode D'emploi

Restoring factory settings

Settings are retained even if the power plug is disconnected .
Follow these procedures to restore the factory default settings and
erase all changes in memory .
1
Press the MENU button for at least five seconds.
"Setup CLR?" (Clear settings?) appears on the display .
2
Press the play (t) button.
The settings are restored to their factory defaults, and "Setup
CLR" (settings cleared) appears on the display .
28
Press for at least
5 seconds

Troubleshooting

If you experience a problem with this product, please take a moment
to review the following information before requesting service .
Moreover, the problem might be caused by something other than
this unit . Please also check the operation of the connected units .
If this product still does not operate correctly, contact the retailer
where you purchased it .
The Grandioso P1X does not turn on.
e Confirm that the power cord is securely connected to both the
inlet on the back of the power supply unit and a power outlet .
e Confirm that power is being supplied to the outlet to which the
power cord is connected by, for example, connecting another
device to it .
e Confirm that the DC power connection cords between the main
and power supply units are properly connected .
The Grandioso P1X automatically turns off.
e This is because the automatic power saving function turned
the Grandioso P1X off .
Press the POWER button to turn it on .
Change the automatic power saving setting if necessary
(page 27) .
Remote control does not work.
e Turn the power supply unit on (page 18) .
e If the batteries are exhausted, replace both of them with new
ones (page 17) .
e The remote control will not work if there are obstructions
between it and the main unit . Point the remote control at the
front panel of the unit from a distance of less than about 7 m
(23 ft) (page 17) .
Another electronic device is malfunctioning.
e Some electronic devices with wireless remote control functions
might malfunction in response to the operation of this product's
remote control .
Playback is not possible.
e Load the disc in the center of the tray correctly .
e If the disc is upside down, reload it with the labeled side up .
e If the disc is dirty, wipe it clean (page 9) .
e If condensation has occurred inside the main unit or the
power supply unit, turn it on and leave it for one to two hours
(page 29) .