Usb Connections With A Computer; Restoring Factory Settings - Esoteric N-01 Mode D'emploi

Troubleshooting (continued)

USB connections with a computer

Computer does not recognize this unit.
e See page 13 for information about supported operating
systems. Operation with unsupported operating systems is not
guaranteed.
There is noise.
e Starting other applications during playback of an audio file
may interrupt playback or cause noise. Do not start other appli-
cations during playback.
e When the unit is connected to a computer via a USB hub, for
example, noise might be heard. If this occurs, connect the unit
directly to the computer.
Audio files cannot be played back.
e Connect the computer with this unit and switch to USB before
starting the audio playback software and audio file playback.
Audio data might not play back correctly if you connect this
unit with the computer or change its input to USB after start-
ing the audio playback software.
Since this unit uses a microcontroller, external noise and other
interference can cause the unit to malfunction. In such a case,
turn the unit off and wait about one minute before restarting
operation from the beginning.
20

Restoring factory settings

Settings are retained even if the power plug is disconnected.
Follow these procedures to restore all settings to their factory defaults
and clear the unit's memory.
1
Turn the unit off.
If the unit is on, press the POWER button to turn it off and wait
for more than 30 seconds.
2
Press the POWER button while holding down
the MENU button.
When "Setup CLR" (clear settings) appears on the display, release
the MENU button.
Note about condensation
If this unit is brought from a cold outdoor environment into a
warm room, or the heater has just been turned on in the room
where it is located, for example, condensation might occur, result-
ing in improper operation. If this occurs, leave the unit on and wait
1–2 hours. This should enable normal playback.