Scheppach HCP2600 Traduction Des Instructions D'origine page 34

13. Troubleshooting
Problem Cause
Pump has following 1. Low pressure spray tip installed.
problems: failure to 2. Water inlet is blocked.
produce pressure, 3. Inadequate water supply.
erratic pressure, 4. Inlet hose is kinked or leaking.
chattering, loss of 5. Clogged inlet hose strainer.
pressure, low water 6. Water supply is over 100°F.
volume. 7. High pressure hose is blocked or leaks.
8. Gun leaks.
9. Spray tip is obstructed.
10. Pump is faulty.
Detergent fails to 1. Detergent siphoning tube is not sub-
mix with spray. merged.
2. Detergent filter is clogged or cracked.
3. High pressure spray tip installed.
Motor runs well with- Motor speed too low.
out load, but under
load „cumbersome"
Engine shuts down Out of fuel.
during operation.
34 | GB
Correction
1. Replace spray tip with high pressure spray tip.
2. Clear inlet.
3. Provide adequate water flow.
4. Straighten inlet hose, patch leak.
5. Check and clean inlet hose strainer.
6. Provide cooler water supply.
7. Clear blocks in outlet hose.
8. Replace gun.
9. Clean spray tip.
10. Contact Authorized service facility.
1. Insert detergent siphoning tube into detergent.
2. Clean or replace filter/detergent siphoning
tube.
3. Replace spray tip with low pressure spray tip.
Contact your customer service.
Fill fuel tank.
www.scheppach.com