Operate The Machine; Start The Machine; Stop The Machine - GreenWorks Pro CRZ426 Guide D'assemblage

Masquer les pouces Voir aussi pour CRZ426:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

11.2

OPERATE THE MACHINE

11.2.1 START THE MACHINE

WARNING
Clear the area of bystanders before operating the mower. If
anyone enters the mowing area, stop immediately and do
not return to mowing until the bystanders leave the area.
a
b
a
Stop / Off
b
On (with lights)
c
Run
d
Start
1. Raise the mower deck to its highest position.
2. Insert start key and turn to start position (d).
The buzzer alarms for one time, the machine is READY
TO GO, then you can drive the machine even without
blade working..
3. Release the parking brake.
English
c
d
NOTE
The key will return back to (c) position automatically.
Wait for 4 seconds until the display shows normally.
4. Place steering control levers in forward (F) position and
drive to desired mowing location.
Turn the headlight on by turning the key to the postion (b)
when you power on the machine.
Use caution when crossing over gravel paths or driveways.
Before crossing, disengage the blades and raise the cutting
deck to the highest position to minimize the possibility of
ricochet. Drive slowly to avoid loss of traction and control.
Do not attempt to change the direction of operation while
the mower is in motion. Always come to a complete stop
before changing the mower direction.
Steering control levers will spring back towards neutral
position if you release them, but you still need to control
them manually to reach neutral position.

11.2.2 STOP THE MACHINE

Never make sudden stops or reverse direction, especially
when maneuvering on a slope. The steering is designed for
sensitive response. Rapid movement of the steering control
levers in either direction could result in a reaction of the
machine that can cause serious injury.
1. Return drive control levers to the Neutral position. Push
drive control levers outward into park brake position.
2. Push down on the PTO switch to turn blades off.
3. Turn the key to OFF position (a).
11.2.3 USE THE USB PORT
USB port
The USB charging port provides charging power of 5 Volts
DC at up to 2.1 amps for your cell phone, MP3 player, or
other USB devices. Consult the owner's manual for your
device for specific charging requirements.
13
NOTE
NOTE
WARNING
NOTE
WARNING
DANGER
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Crz428

Table des Matières