GreenWorks Pro CRZ426 Guide D'assemblage page 34

17 TROUBLESHOOTING
Problem Cause
The machine 1. There is no battery pack in the battery compart-
does not move. ment, or the battery inserted is not Greenworks
designed.
2. The battery pack is out of power.
3. The steer control lever is in the NUETRAL posi-
tion.
4. There is no person sitting on the seat or the seat
switch is not connected.
5. The PTO switch, or the the left and right steer
control levers are not in the original position
when the machine power is on.
6. The battery pack that controls the drive function
is in sleep state.
Sudden break- 1. The battery is out of power.
down during
2. The seat switch is disconnected on rugged or
driving.
bumpy roads.
3. The accelerator fails.
4. The vehicle controller fails.
The blade fails 1. There is no Greenwoks designed battery pack in
to run when you the battery compartment.
pull up the PTO
2. The battery pack is out of power.
switch.
3. The seat switch is not connected.
4. The PTO switch is not pushed when the machine
is powered on.
5. The blade motor is blocked or other functional
protection.
The blade stops 1. The blade motor is overheated.
running during
2. The deck is full of grass and garbage.
the mowing
3. The blade motor is overloaded.
process.
4. The battery pack termperature is too high.
5. The battery is undervoltage.
6. The blade is hit by a foreign object, causing the
blade to stop suddenly for protection.
English
Solution
1. Make sure at least one Greenwoks designed bat-
tery pack is inserted in the battery compartment.
2. Check the battery capacity.
3. Make sure the steer control levers are not in the
parking slots.
4. Make sure the operator is sitting on the seat.
5. Return the steer control lever and PTO switch to
the original position, restart the machine. If the
machine still fails to work, contact the service
center for help.
6. Turn the key to the OFF position, and restart the
machine 5 seconds later.
1. Make sure at least one Greenwoks designed bat-
tery pack is inserted in the battery compartment.
Make sure the battery pack has power.
2. Return the steer control lever to original position,
restart the machine, operate the steer control lev-
er to check if the machine works normally.
3. Contact a technical people for help.
1. Make sure at least one Greenwoks designed bat-
tery pack is inserted in the battery compartment.
Make sure the battery pack has power.
2. Check the battery capacity.
3. Make sure the operator is sitting on the seat.
4. Push down on the PTO switch, restart the ma-
chine.
5. Cut the grass in low blade speed when you power
on the machine, set the blade speed to high posi-
tion once the machine cuts normally. Check if the
connection between the blade and motor is with-
out grass or foreign objects to ensure the blade
rotates smoothly.
6. Turn the key to the OFF position, and restart the
machine 5 seconds later.
1. Do not use the machine too much, power off the
machine for 5min. Raise the deck height or re-
duce the driving speed to protect the blade.
2. Clean the deck to ensure that the blade rotation is
normal.
3. Push down on the PTO switch; restart the ma-
chine. Raise the deck height or reduce the drive
speed to protect the blade.
4. The battery pack that controls the blade system
enters under-voltage protection state, and the bat-
tery should be charged immediately
5. Turn the key to the OFF position, and restart the
machine 5 seconds later.
33
EN