GreenWorks Pro CRZ426 Guide D'assemblage page 35

EN
Problem Cause
The machine 1. The blade is dull.
cuts the grass
2. The blade is bent.
unevenly.
3. The deck is uneven.
The actual cut 1. The bolt of the deck is loose.
height does not
2. The deck is severely worn or damaged.
match the cut
height you set.
The machine 1. The grass is too wet.
cuts the grass
2. The grass amount you set is too much.
abnormally.
The machine vi- 1. The blade is loose.
brates too much.
2. The blade is bent.
3. The deck is uneven.
4. The deck is loose.
5. The blade cuts too much grass more than the
There is grass or 1. The blade cuts too much grass more than the
debris on the
ground after
2. The grass is too wet.
mowing.
3. You drive too fast.
4. The blade speed is too low.
The cutting en- Heavy grass can short the running time of the lawn
durance time is mower.
short.
The machine is The tire pressure of the left and right rear wheel is
off the track. different.
The machine Improper cleaning, water enters electronic compo-
fails to start af- nents such as LCD or battery compartment.
ter cleaning.
The mower is The deck is full of weeds and garbage.
blocked.
amount you set.
amount you set.
English
Solution
1. Grind the blade according to the manual.
2. Replace the bent blade, replace the blade accord-
ing to the instructions in the manual, and wear
protective equipment.
3. Adjust the cutting deck according to the instruc-
tions in the manual to ensure the left and right
deck height are even.
1. Adjust the cutting deck bolt, make sure the deck
is not loose. Please balance the deck level after
each adjustment.
2. Replace with a new cutting deck.
1. Please check the grass before working. If the
grass is too wet, please wait until the grass gets
drier.
2. If the grass is too intensive and high, raise the
deck height, and avoid cutting intensive grass.
1. Grind the blade according to the manual.
2. Replace the bent blade, replace the blade accord-
ing to the instructions in the manual, and wear
protective equipment.
3. Adjust the cutting deck according to the instruc-
tions in the manual to ensure the left and right
deck height are even.
4. Tighten the fixing bolts of the deck.
5. If the grass is too intensive and high, please raise
the cutting deck and try to avoid cutting intensive
grass.
1. If the grass is too dense and high, please raise the
cutting deck. If the grass height exceeds 6 inch,
please cut the area repeatedly. Try to avoid cut-
ting intensive grass.
2. Please check the grass before working. If the
grass is too wet, please wait until the grass gets
drier.
3. Reduce the drive speed.
4. Turn the blade speed to high position.
Raise the cutting deck and reduce the blade speed to
extend the running time.
Check the tire pressure of the machine regularly ac-
cording to the instructions.
1. When cleaning the machine, please clean it ac-
cording to the instructions.
2. If the vehicle is accidentally exposed to rain,
please put the vehicle in a dry place for 12 hours
or dry it before use.
3. Contact a service center for help.
Please clean the machine correctly according to the
instructions after each use.
34