Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
#
Name
Function
2
Digital dis-
This display shows important electrical
play
system information. Refer to the Electri-
cal section for complete information.
3
ON/OFF for
Pull the PTO switch up to activate the
blade (PTO)
mower's cutting blades. Push the knob
down to stop the cutting blades.
4
High/Low
High blade mode is a higher blade speed
for blade
for cutting thicker grass, while low blade
speed
mode provides lower blade speed for
lower battery consumption on thinner,
drier grass areas. Press it for high blade
speed, the green light will be on. Pull it
for low blade speed, the light will be off.
Mowing time will be increased when
mowing in low blade mode.
5
High/Low
Allows operators to select a comfortable
for driving
driving speed. Pressing it to "High
speed
Speed" position means that the maxi-
mum drive speed will be 8 mph, the
green light will be on. Pull up it to "Low
Speed" position means that the maxi-
mum drive speed will be 4 mph, the light
will be off. Pull it up to "Low Speed" po-
sition for inexperienced operators or
when trimming around objects, buildings
and other obstacles.
Get comfortable with mower before us-
ing "High Speed" setting. The maxi-
mum speed may be adjusted at any
time, whether the mower is in motion
or not.
7.2
INSTALL THE ROLL OVER
PROTECTION STRUCTURE
(ROPS)
WARNING
The left and right steering levers should be adjusted so that
they align with each other when in the neutral position.
NEVER install the steering levers in an asymmetrical
operating height.
English
NOTE
NOTE
9
Bolt and washer assembly
Bolt and washer assembly
1. Lift one steering lever to align the holes in the steering
lever with the holes in the corresponding mounting pole.
Select the preferred steering-lever operating height, and
then use the wrench (13*16mm) to secure the steering
lever as indicated below.
2. Assemble the other steering lever and in the same way.
CAUTION
Do not install the upper handle reversely.
7.3
STEERING CONTROL LEVERS
The two levers control the mower's speed, direction,
stopping, neutral lock, and parking brake. Levers are used to
steer, accelerate, decelerate, stop, and change direction. When
the control levers are in the park brake position, the mower
will not move.
7.4
ANTI-SCALP WHEELS
Anti-scalp wheel kits are standard on Greenworks
Commercial units. These anti-scalp wheels (23) are designed
to minimize scalping when mowing on rough, uneven terrain.
After setting the cutting height, adjust the anti-scalp wheels
so they extend below the deck but do not contact the ground.
They should always be at least 1/4" to 3/4" below the deck.
With the unit sitting on a flat level surface, the wheel position
can be adjusted up or down as needed from 3/4" to 1-3/4"
below the blade surface. Move the wheels up or down - using
the different axle mount holes in the wheel mount bracket (if
applicable on model).
EN
Publicité
Table des Matières
