Fault Code - GreenWorks Pro CRZ426 Guide D'assemblage

13

FAULT CODE

Dis- Description
play
The left steering
control lever
fails.
The right steer-
ing control lever
fails.
The machine
does not work
when the ma-
chine is pow-
ered on.
The potentiometer on the left steer-
ing control lever fails.
The potentiometer connector on
the left steering control lever is
loose.
The potentiometer on the right
steering control lever fails.
The potentiometer connector on
the right steering control lever is
loose.
Before the machine is powered on,
the PTO switch is ON.
Before the machine is powered on,
the left steering control lever is
ON.
Before the machine is powered on,
the right steering control lever is
ON.
After the whole machine is pow-
ered on, the output signal of the
left or right accelerator is abnor-
mal.
The PTO switch is on when the
machine is powered on, but the op-
erator is not in the seat.
The left steering control lever is
not in the Neutral postion when the
machine is powered on, but the op-
erator is not in the seat.
The right steering control lever is
not in the Neutral postion when the
machine is powered on, but the op-
erator is not in the seat.
The operator leaves the seat during
operation.
The operator is in the seat, and the
machine is powered on, one steer-
ing control lever is in the Neutral
position but the other is not.
English
Fault code on Cause
LCD
V17 The potentiometer fails.
The connector is loose.
V18 The potentiometer fails.
The connector is loose.
V15 Before the machine is
powered on, the PTO
switch, left steering con-
trol lever, and right steer-
ing control lever are not
in the initial position.
V16 The operation is not cor-
rect.
23
EN
Solution
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Turn off the
PTO switch.
Turn off the left
steer control
lever.
Turn off the
right steer con-
trol lever.
Contact a speci-
fied service cen-
ter.
Push down the
PTO switch.
Make sure the
left steering
control lever is
in the N posi-
tion.
Make sure the
right steering
control lever is
in the N posi-
tion.
Do not leave the
seat. (except
emergent condi-
tions.)
Return the steer-
ing control lev-
ers to the N po-
sition when the
operator leaves
the seat.