GreenWorks Pro CRZ426 Guide D'assemblage page 25

EN
Dis- Description
play
The left or right
drive motor
does not work.
The 9pin connector between the
vehicle wire harness and the left
drive controller is loose.
The 9pin connector between the
vehicle wiring harness and the
right drive controller is loose.
The 10pin connector between the
vehicle wire harness and the bat-
tery compartment is loose.
The 4pin connector between the
vehicle wiring harness and the seat
switch is loose.
Poor contact of seat switch con-
nector.
The PCBA that controls the left
and right drive motors fails.
The 16pin connector between the
vehicle wire harness and the left
controller is loose , Or the 16pin
connector between the vehicle wire
harness and the right controller is
loose.
A high-voltage battery pack is in-
serted in the of the battery com-
partment.
A low-voltage battery pack is in-
serted in the of the battery com-
partment.
The power of the battery pack in
the of the battery compartment is
too low.
English
Fault code on Cause
LCD
V11 The connector is loose.
V14 The connector is loose.
V21 The connector is loose.
V27 The connector is loose.
Seat switch fails.
TR13, TL13, The PCBA fails.
TR22, TL22,
TR24, TL24,
TR25, TL25,
TR32, TL32
V31, TR23 The connector is loose.
TR11, TL11 Wrong battery pack ap-
plied.
TR12, TL12 Wrong battery pack ap-
plied.
The battery capacity is
not high enough.
24
Solution
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Check the bat-
tery pack.
Check the bat-
tery pack.