GreenWorks Pro CRZ426 Guide D'assemblage page 28

Dis- Description
play
The left or right The 6pin connector between the
blade does not left blade motor and the vehicle
work. wire harness is loose.
The left blade motor fails.
The 6pin connector between the
right blade motor and the vehicle
wire harness is loose.
The right blade motor fails.
The PCBA that controls the left
blade motor fails.
The PCBA that controls the right
blade motor fails.
The phase wire connector between
the left blade motor and the left
blade controller is loose.
The phase wire connector between
the right blade motor and the right
blade controller is loose.
The left blade controller tempera-
ture is too high.
The right blade controller tempera-
ture is too high.
The left or right The left blade motor fails.
blade does not
The 6pin connector between the
work.
left blade motor and the left blade
controller is loose.
The right blade motor fails.
The 6pin connector between the
right blade motor and the left blade
controller is loose.
The left blade motor temperature is
too high.
The right blade motor temperature
is too high.
The 30pin connector between the
vehicle wire harness and the right
blade controller is loose.
The 30pin connector between the
vehicle wire harness and the right
blade controller is loose.
English
Fault code on Cause
LCD
ML15 The connector is loose.
The motor fails.
MR15 The connector is loose.
The motor fails.
ML16, ML18 The PCBA fails.
MR16, MR18 The PCBA fails.
ML17 The connector is loose.
MR17 The connector is loose.
ML21 The controller tempera-
ture is too high.
MR21
ML22 The motor fails.
The connector is loose.
MR22 The motor fails.
The connector is loose.
ML23 The motor temperature is
too high.
MR23
ML25 The connector is loose.
MR25 The connector is loose.
27
EN
Solution
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Power off the
machine, and
power on again
after the control-
ler cools down
for a while.
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.
Power off the
machine, and
power on again
after the control-
ler cools down
for a while.
Contact a speci-
fied service cen-
ter.
Contact a speci-
fied service cen-
ter.