Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Turn the key to the "OFF" position before unclogging the
discharge chute.
•
Never clear the discharge chute with the machine
running. Turn the key to the "OFF" position and be sure
the blades have stopped before cleaning. Use a stick to
clear a plugged discharge area. Never use your hand!
•
Stop unit and allow blades to stop before unclogging
chute. Grass collection system components are subject to
wear, damage and deterioration, which could expose
moving parts or allow objects to be thrown. Frequently
check components and replace with manufacturer's
recommended parts, when necessary.
•
Exercise caution when working under the deck as the
mower blades are extremely sharp. Wear gloves and use
extra caution when servicing them.
•
Use only genuine Greenworks Mower parts to ensure that
original standards are maintained.
•
Always remove batteries when transporting unit. Keep
unit free of grass clippings, leaves and other debris.
•
Check brake operation frequently. Adjust and service as
required.
•
Maintain or replace safety and instruction labels, as
necessary.
•
Have your ride-on lawn mower serviced by a qualified
repair person using only identical replacement parts. This
will ensure that the safety of the ride-on lawn mower is
maintained.
•
Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type of
battery pack may create a risk of fire when used with
another battery pack.
15
TRANSPORTATION
Use extra care when loading or unloading the machine into a trailer. Press the low speed drive button and carefully move the
drive levers as needed to control the speed. Always back onto the trailer when loading. When loading or unloading the mower,
do not exceed the maximum recommended operation angle of 15°. Failure to follow these instructions can result in loss of
control and result in death, serious personal injury, or property damage.
Use care when loading or unloading the mower onto a trailer. Ensure the cutting deck is raised to the highest position so that it
is not caught on the ramp. The wheels on the mower can go off the ramp or trailer, causing the mower to pivot or tip over, and
result in a crush hazard that can cause death or serious personal injury.
1. Park the mower on a level surface.
2. Raise the cutting deck to the highest position.
3. Position and secure ramp to the trailer according to manufacturer's instructions.
We recommend you use one full width loading ramp that is at least 1 ft. wider than the mower to minimize the risk of the
mower's wheels going off the side of the ramp.
4. Slowly back the mower onto the ramp and into the trailer.
5. Lower mower deck completely.
English
WARNING
WARNING
NOTE
31
EN
Publicité
Table des Matières
