AL-KO MULTITOOL MT 40 Traduction De La Notice D'utilisation Originale page 29

Installation and start-up
Insert the protective ring with line cutter (04)
1. Position the protective ring (04/1) in such a
way above the guard plate (04/2) that the line
cutter (04/3) points inwards towards the cut-
ter head (04/4).
2. Pushing in the protective ring:
■
First press (04/a) the two long pins (04/5)
exactly in the second compartment
(04/6).
Note: If one of the two pins is pressed in
one of the neighbouring compartments,
the protective ring is not tight enough.
■
Then press all latching hooks (04/7) from
left to right in the holding openings (04/8)
until they are all engaged (04/b).
4.2 Installing the hand grip
See "Multitool MT 40 – basic appliance" operat-
ing instructions.
4.3 Fitting the spacer (05)
1. Screw (05/a) spacer (05/1) on the rotating/
locking joint (05/2) of the already mounted
hand grip (05/3).
4.4 Removing/fitting the spool
head (06, 07, 08)
Mounting the line head
1. If fitted: Remove the blade (see chapter 4.5
"Fitting/removing the blade (09, 10)",
page 29).
2. Insert the retaining pin supplied (06/1) into
the hole (06/2) of the drive pulley (06/3) and
hold.
3. Put the filling washer (06/4) onto the drive
shaft (06/6) with the front edge (06/5) to-
wards the outside, i.e. away from the cutter
head (06/7).
4. Put the spool head (07/1) onto the drive shaft
of the cutter head (07/2).
5. Turn the spool head (08/1) clockwise and
then firmly tighten. Brace with the retaining
pin (06/1) to attach the spool head safely to
the drive shaft (08/a).
6. Remove the retaining pin (06/1).
442349_a
WARNING!
Risk of injury due to de-
taching appliance parts
Appliance parts detaching
during operation can lead
to serious injury.
■
Attach the cutting tools
so that they cannot
come loose during oper-
ation.
Dismantling the spool head
1. Insert the retaining pin supplied (06/1) into
the hole (06/2) of the drive pulley (06/3) and
hold.
2. Turn the spool head (08/1) anti-clockwise
and then remove (08/b). Brace with the re-
taining pin (06/1).
3. Remove the retaining pin (06/1).
4. Remove the filling washer (06/4).
4.5 Fitting/removing the blade (09, 10)
Fitting the blade
1. If fitted: Remove the spool head (see chapter
4.4 "Removing/fitting the spool
head (06, 07, 08)", page 29).
2. Insert the retaining pin supplied (09/1) into
the hole (09/2) of the drive pulley (09/3) and
hold.
3. Put the blade (09/4) and washer (09/5) onto
the drive shaft (09/6). The inscription on the
blade must point outwards, i.e. away from the
cutter head, (covered in the figure of the
washer).
4. Put the locknut (10/1) onto the drive shaft
and firmly tighten by hand in a clockwise dir-
ection.
5. Firmly tighten the locknut (10/1) with the
socket wrench (10/2) provided. Brace with
the retaining pin (09/1) to attach the blade se-
curely to the drive shaft.
29