Connecting The Power Supply - Videotec MAXIMUS MMX Manuel D'instructions

6.6 Connecting the power supply

6.6.1 Connecting the power supply,
24Vac/24Vdc (version of the product
not cabled)
Check that the power supply socket and
cable are adequately dimensioned.
The polarity of the voltage, applied to the
power terminal, is irrelevant.
CONNECTING THE POWER SUPPLY
Power supply 24Vac/24Vdc
Colour Terminals
Defined by the installer ~/+
Defined by the installer ~/-
Tab. 6
CABLES SPECIFICATIONS
Cable section Supply voltage
1.5mm (16AWG) 24Vdc
2
24Vac
Tab. 7
The power supply cable must be covered
by the silicone sheath (01) supplied. The
silicone sheath must be fastened with the
corresponding cable tie (02).
N/-
L/+
Fig. 21
The power supply cables should be connected to the
power supply terminal of the housing board (J1, 6.5
Housing board description, page 18).
6.6.2 Connecting the power supply,
PoE+ (version of the product not
cabled)
The product can be powered using PoE+ (Power
Over Ethernet) devices in compliance with the
international standard for technological information
IEEE 802.3at, using an Ethernet data cable Category
5E.
MNVCMMX_2223_EN
Cable section
from 0.14mm² (28AWG)
up to 1.5mm² (16AWG)
from 0.14mm² (28AWG)
up to 1.5mm² (16AWG)
Maximum cable
length
20m (66ft)
40m (131ft)
01
02
Maximum Ethernet cable length (category
5E): 100m.
The PSE (Power-Supplying Equipment) devices
suitable for the product power supply must comply
with the standard IEEE 802.3at (PoE+).
The Ethernet cable should be connected to
connector RJ45 of the housing board (J8, 6.5
Housing board description, page 18).
The Ethernet cable shield must always be
earthed via the connector. Always use a
shielded RJ45 connector.
Carry out the connections as described in the table
(according to the standard specifications: TIA/EIA-
568-B).
ETHERNET CABLE CONNECTION
Pin number Core colour
1 Orange-White
2 Orange
3 Green-White
4 Blue
5 Blue-White
6 Green
7 Brown-White
8 Brown
Tab. 8
6.6.3 Connecting the power supply,
24Vac/24Vdc (version of the product
cabled)
Carry out the connections as described in the table.
CONNECTING THE POWER SUPPLY (24VAC/24VDC)
Colour Function
Black 1 ~/+
Black 2 ~/-
Tab. 9
6.6.4 Connecting the power supply,
PoE+ (version of the product cabled)
The product can be directly connected to an
Ethernet switch equipped with a PoE+ (End-Span
configuration) port or a classic Ethernet switch using
a PoE Injector (Mid-Span configuration).
Cable section
1.5mm² (16AWG)
1.5mm² (16AWG)
19