Wall Mounting; Sunshield Mounting - Videotec MAXIMUS MMX Manuel D'instructions

6.1.2 Wall mounting

The product can be installed on a wall.
Fasten the fastening support (01) to its final
installation surface.
Tighten the screws.
Attach the housing support (03) to the fastening
support (01) using the M8 screw (05), washers and
nut. Once the final position of the product is defined,
fully tighten the M8 screw (05) and fasten the M5
screws (08) to block rotation.
The cable connected to the housing could hinder
operations You can, by dismantling the sunshield,
rotate the housing 180° (6.2 Sunshield mounting,
page 17).
Fig. 14 Housing in normal position.
Fig. 15 Housing in overturned position.
MNVCMMX_2223_EN
08
01
08
05
03
08
01
08
05
03
Fig. 16 Rear view of completed installation.
Pay attention to the fixing. Tightening
torque: M5 screws, 9Nm (±0.5Nm). M8
screw, 16.5Nm (±0.5Nm).

6.2 Sunshield mounting

The product is supplied with the sunshield already
installed.
For installation or maintenance needs, the sunshield
can be dismantled. Unscrew the sunshield screws
and remove it.
Re-assemble the sunshield before fastening the
housing to the housing support.
Pay attention to the fixing. Tightening
torque: 6Nm (±0.5Nm).
Fig. 17
17