Technical Specifications - I-Tech MIO-CARE Tens Mode D'emploi

16. Technical specifications.

Risk class: Class II in accordance with the 93/42/EEC directive.
Isolation class: Internally powered device with type BF applied parts, in accordance with
the EN 60601-1 standard.
Classification: IP30, based on the penetration of liquids and powder; equipment not
protected.
Housing: ABS.
Power Supply: Ni/Mh rechargeable battery 4.8V 800mAh.
Average
consumption: 1 W.
Limitations: equipment not suitable for use in environments with a high concentration of
oxygen and/or flammable liquids and/or flammable gas; do not use with
equipment for electrosurgery or short-wave or microwave therapy.
Operation: equipment suitable for continuous operation.
Output channel: 2 channels, independent and galvanically isolated.
Output current: maximum power, peak to peak 200mA, 30mA max. effective per single
channel with load of 1Kohm.
Type of impulse: compensated, biphasic, rectangular.
Frequency: operates with a range of impulses from 1 Hz to 150 Hz.
Impulse amplitude: from 40µs to 800µs (sum of the two semi-impulses).
Display: reflective LCD display.
Control keypad: 7-key keypad in ABS.
Dimensions: 136X61X21 mm.
Weight: 160 gr. including batteries.
Battery charger: mains supply 100-240Vac / 50/60Hz, output DC6,0V / 300mA max.
Use the battery charger supplied by the manufacturer. The use of other
battery chargers can seriously compromise the safety of the entire device
and that of the user.
Maintenance
and storage: refer to the instructions in Chapter 8 "Maintenance and storage of MIO-
CARE".
Warning: the equipment delivers current in excess of 10mA.
Produced in compliance with the 93/42/EEC directive concerning medical
devices
IACER S.r.l.
56
MNPG04 Rev. 03 Ed. 02/09